Many effect pedals allow external footswitches to be connected to them. The Aux-Tap Strip is an ultra-compact solution to integrate several of these external footswitches into one enclosure - which fits in the front row of your pedalboard. Due to the very low height, all effect pedals behind remain easily accessible.
The Aux-Tap Strip is just 30mm deep and 20mm high (enclosure dimensions), with the built-in footswitches it is approx. 36mm high - significantly less than most effect pedals.
Where jack sockets are mounted, it's depth is 40mm.
The Aux-Tap Strip is basically available in any width. For example, you have a Strymon Timeline, a DOD Rubberneck, an Amp Channel Switch, and a Boss LoopStation? Then a Aux-Tap Strip with 8 momentary footswitches and one latching footswitch is the solution for you.
There are the following available "modules":
One momentary footswitch:
- Normally Open (e.g. as a tap tempo switch for many effect pedals) or
- Normally Closed (e.g. as a tap tempo switch for boss delays)
Two momentary footswitches:
- Normally Open (e.g. for Source Audio Nemesis and many other pedals) or
- Normally Closed (e.g. for Boss Loop-Stations, Boss ES-8, Boss DD-500 etc.)
Three momentary footswitches:
- Strymon Multiswitch clone or
- Diode configuration (e.g. for DOD Rubberneck, Eventide H9, GFI Specular Tempus etc.)
Four momentary footswitches:
- Meris Preset Switch clone or
- Red Panda Remote 4 clone
Four to eight momentary footswitches:
- Resistor Ladder (for Morningstar MC3, MC6MKII, MC8 - up to 16 footswitches for controllers from the PRO series)
A latching footswitch (e.g. to switch the channel of the amp) can also be installed. A wide variety of configurations (e.g. for Orange amplifiers, etc.) are possible, and double foot switches are also possible.
The individual footswitches are about 63mm apart. The width is (number of footswitches x 63 mm + 10 mm). 2mm thin DualLock is included for attachment to the pedalboard.
It is best to contact me before you place your order and together we will discuss the best solution for you.
3-fach Taster für Eventide H9 und 2 Schalter für einen Fender Amp (Tremolo & Reverb)
Tap Tempo für Boss Delay und zwei Strymon Multiswitch Klone in einem Gehäuse
Die linken beiden Taster steuern den Eventide H9, die rechten beiden Taster sind Erweiterungstaster (mit LEDs) des RJM Mastermind PBC und es gibt noch eine zusätzliche Buchse um ein Expression Pedal an den H9 anzuschließen.
* Die Nennung und Abbildung von Marken dient ausschließlich dem Informationszweck. Verwendete Markennamen sind Eigentum der jeweiligen Besitzer.
