This Aux-Tap is a clone of the Meris Preset Switch – with one improvement:
It is also possible to control two compatible effects at the same time. Footswitch 1 then loads Preset 1 for both effects, etc. Of course, you can also connect just one effect.
- Easily store and instantly recall up to 4 presets
- Two output jacks for simultaneous connection of two Meris effects
- Connection with one or two stereo cables (TRS)
- Enclosure width is approximately the width of two Meris effects
- Works with Enzo, Hedra, Mercury7, Ottobit Jr & Polymoon
Well thought-out design
Thanks to the custom-designed aluminium enclosure, Aux-Taps have a place on every pedalboard - preferably in the first row.
The very high-quality and quiet footswitches are easy to operate thanks to the sufficient spacing and slight forward tilt.
All connections are located on the sides so that effects can be placed directly behind the Aux-Tap - they are also easy to reach thanks to the enclosure height of less than 3 cm. The connections are offset slightly inwards in the enclosure so that the jack plugs do not protrude far.
Setup guide
Refer to your pedal's Quick Start Guide for details, but in general this is how the setup process works:
- Set your Meris pedal EXP jack to “PRESET” using the pedal’s global configuration mode by holding the ALT switch on power up for 3 seconds.
- Then select the "PRESET" mode with the appropriate knob (bottom row, rightmost knob).
- Unplug your pedal to store the setting.
- Connect the Preset Switch using a TRS cable and power your Meris pedal normally.
Usage:
- To recall preset 1-4, press the corresponding footswitch.
- To save your own preset, press the desired footswitch, change the sound to your liking, then hold the ALT button on your Meris pedal.
| Item information |
Value |
| Power supply necessary: |
No |
| Dimensions (W x H x D): |
233 x 40 x 44 mm |
Product safety information
Manufacturer information:
Constantin Eckstein
Kreuzgasse 11, 72581 Dettingen an der Erms, Deutschland
info@looperwerk.de
